Manual de kansai special 1508p

INSTRUCTION

Industrial Sewing Machines

First published : June 1997 Second edition : March 2001

No. 010012

INTRODUCTION

Thank you for your purchasing Kansai Special's DLR Series. Read and study this instruction manual carefully before beginning any of the procedures and save it for later use.

1. 2. 3. 4. 5. 6.

This instruction manual describes adjustments and maintenance procedures on this machine. Before starting the machine, check to make sure the pulley cover, safety cover, etc. are secured. Before adjusting, cleaning, threading the machine or replacing the needle, be sure to turn off the power. Never start the machine with no oil in the reservoir. Refer to the parts list as well as this instruction manual before performing preventive maintenance. The contents described in this instruction manual are subject to change without notice.

CONTENTS
1. SPECIFICATIONS
1-1 Stitch type 1-2 Model 1 1

10. ADJUSTING THE REAR PULLER DEVICE
10-1 Manual lever 10-2 To adjust the puller pressure 10-3 Adjusting the feeding amount of the rear puller 12 12 12

2. NEEDLES & THREADING THE MACHINE
2-1 Needles 2-2 Replacing the needle 2-3 To thread the machine 1 1 2

11. ADJUSTING THE STITCH FORMATION
11-1 Thread tension adjustment 11-2 Position of the needle thread eyelet 11-3 Adjusting the needle thread guard 11-4 Adjusting the looper thread eyelets 11-5 Position of the looper thread take-up 13 13 13 13 14

3. MACHINE SPEED
3-1 Machine speed & direction in which the machine pulley runs 4 3-2 Motor & belt 4

12.

ADJUSTING

THE

FRONT

PULLER

4. LUBRICATION
4-1 Oil 4-2 To fill the machine with oil 4-3 Replacing the oil and the filter element 5 5 5

DEVICE
12-1 To insert elastic and adjust the feeding amount of the front puller 14

5. SEWING MACHINE INSTALLATION
5-1 Cutting the machine table 5-2 To install the machine 6 7

13. CLEANING THE MACHINE

14

6.

TIMING

OF

THE

LOOPER

TO

THE
7 8 8 9 9 10

NEEDLE
6-1 To install the looper 6-2 Looper left-to-right movement 6-3