Excavadora 345 AGS

Principio del formulario
Pruebas y Ajustes
345B Series II Excavator Hydraulic System
Número de medio -RENR3744-13 Fecha de publicación -01/09/2009 Fecha de actualización -17/09/2009

   
i01583906
Relief Valve (Main) - Test and Adjust
SMCS - 5069-025; 5069-081
Final del formulario
Principio del formulario

Position the machine on level ground and stop the engine.
Release the pressure in the hydraulic system. Refer to Testing And Adjusting, "Hydraulic System Pressure - Release".

Illustration 1 g00694582

Pump compartment
(1) Pressure tap (power shift pressure)
(2) Pressure tap (upper pump delivery pressure)
(3) Pressure tap (lower pump delivery pressure)
Attach a 60000 kPa (8700 psi) pressure gauge to pressure tap (2) .
Start the engine.
Place the machine controls at the following settings: Power Mode and engine speed dial "10".
Note: The engine will not reach maximum no-load speed until the hydraulic tank pressure has reached the operating level.
Increase the hydraulic oil temperature to 55° ± 5°C (131° ± 9°F).
Open the bucket until the bucket cylinder rod is at the full retraction.
Check the main relief valve pressure setting at pressure tap (2) .

Illustration 2 g00299702

Top of main control valve
(4) Adjustment screw
(5) Locknut
(6) Main relief valve
Return the control lever to the NEUTRAL position. Adjust the main relief valve pressure to 34320 ± 490 kPa (4980 ± 70 psi).
To adjust the main relief valve pressure, loosen locknut (5) and turn adjustment screw (4) until the pressure gauge reading at pressure tap (2) is 34320 ± 490 kPa (4980 ± 70 psi).
Tighten locknut (5) to a torque of 50 ± 10 N·m (37 ± 7 lb ft).
Note: Turning adjustment screw (4) clockwise increases the pressure. Turning adjustment screw (4) counterclockwise decreases the pressure.
Note: Always make final pressure adjustments on pressure rise.
Temporary Setting of the Main Relief Valve
Note: A temporary setting of the main relief valve is required before any line relief valve